V2376j amp4mic microphone preamp api ® 500 System
V2376j amp4mic functions
• V - Basic gain, setting range from 26 dB to 76 dB
• pad -20dB - Pre-attenuation -20 dB, illuminated push button for activation
• Z - Impedance, continuously adjustment of the impedance from 150 ohm to 22 kOhm
• LF - High pass filter, attenuation from 0 down to -17 dB based on 20 Hz
• MF - Mid frequency equalization, adjustable from 155 Hz to 3.5 kHz, +/- 10 dB level range
• Q - Quality of MF equalization, toggle switch Q = 0.4 / 1.5 fixed and adjustable (trim Q=>)
• trim Q=> - Variable quality, Q-factor via trimmer from 0.4 to 1.7 adjustable
• HF - High frequency equalization via Baxandall tone control +/- 12 dB based on 5 kHz
• bypass filter - Deactivation of the filter functions by means of a pressure switch
• +48 V - Phantom power switchable by means of pressure switch
• meter - Multi LED panel, level monitoring and overload display
• All parameters except the Q-factor can be adjusted continuously
The V2376j microphone amplifier allows the universal adaptation of passive transducers (ribbon-, plunger coil-, coal-, piezo-, crystal-microphone) to the program material and the recording situation. With a continuously adjustable preamplification range of 26 dB to 76 dB and a switchable attenuation (-20 dB pad) the development of exotic transducers was also taken into account.
The unique continuously adjustable impedance by means of the impedance potentiometer (Z) was designed generously from 150 Ohm to 22 kOhm in order to optimize the linear transfer function by changing the load impedance. The impedance mismatch turns this function into a powerful creative tool.
The tonal adjustment for the high frequency range takes place via a Baxandall filter, in the mids through a semi parametric equalizer and at low frequencies by means of a high-pass filter.
All filter parameters can be changed continuously, i.e. steplessly. An illuminated bypass filter pressure switch is available to check the effect of the set filters.
A switchable +48 V phantom power is integrated for the use of microphones with external power supply. In this case, the impedance matching is switched off to a fixed value of 22 kOhm to protect the active sound transducer.
The V2376j can be installed in any api 500® environment. High-quality ALPHA ® potentiometers / faders and illuminated push switches from eao ® as well as the gold-plated connection strip guarantee long and trouble-free operation in continuous use.
Applications
Microphone preamplifier with three integrated filters, creative tool for passive microphones through the combination of filters and mismatching of the impedance regulator, installation in a moderator's or a speaker's desk, filter unit to increase speech intelligibility
Datasheet
|